RESUMO O setor da construção civil vem absorvendo resíduos de vários segmentos industriais e transformando-os em componentes para utilização nas construções, através da sua incorporação em materiais, como por exemplo em argamassas e concretos. Devido a este fato, o presente estudo tem o objetivo de avaliar o comportamento de argamassas com diferentes substituições de agregado miúdo por resíduo de borracha, conferindo seu comportamento físico e mecânico. Com a finalidade de verificar a melhor relação de substituição, os ensaios foram realizados em argamassa referência e em argamassas com resíduos nas proporções de 2,5%, 5%, 10% e 15% de substituição de areia por borracha, possuindo, portanto quatro famílias de argamassas com resíduos de borracha, sendo o traço referência o 1:3 (cimento:agregado). Para confecção das argamassas, os agregados, areia e borracha, foram divididos em quatro frações granulométricas, gerando quatro subfamílias de argamassas para cada família de argamassa com resíduos. Para caracterização das argamassas foram realizados ensaios de índice de consistência, de compressão axial, de resistência à tração por compressão diametral, de absorção por capilaridade e de absorção por imersão. Com base nestes ensaios foram escolhidos dois traços de argamassa para revestirem dois protótipos de alvenaria, visando verificar o comportamento do revestimento. Os protótipos foram analisados visualmente em relação ao surgimento de manifestações patológicas e foram ensaiados quanto a absorção de água por meio do método cachimbo. Os resultados indicam que nas argamassas com resíduo ocorreu um decréscimo nas resistências. Nas absorções algumas subfamílias possuíram melhor desempenho que a argamassa referência. Para os protótipos a utilização de borracha não influenciou o comportamento do revestimento argamassado e a permeabilidade pelo método cachimbo se mostrou sem diferenças significativas quanto aos resultados obtidos.
ABSTRACT The construction industry has been absorbing waste from various industrial segments and transforming them into components for use in construction, through its incorporation in materials such as mortars and concretes. Due to this fact, this study aims to evaluate the behavior of mortars with different substitutions of small aggregates for rubber residue, conferring their physical and mechanical behavior. In order to verify the best substitution ratio, the tests were carried out on reference mortar and mortar with residues in the proportions of 2,5% wt, 5% wt, 10% wt and 15% wt of substitution of sand by rubber, the reference trace is 1: 3 (cement: aggregate). For the preparation of the mortars, the aggregates, sand and rubber were divided into four granulometric fractions, generating four subfamilies of mortars for each family of mortar with residues. For characterizing of the mortars, tests of consistency index, axial compression, tensile strength by diametrical compression, absorption by capillarity and absorption by immersion were performed. Based on these tests two traces of mortar were chosen to cover two prototypes of masonry, in order to verify the behavior of the coating mortar. The prototypes were analyzed visually in relation to the appearance of pathological manifestations and were tested for water absorption by the pipe method. The results indicate that in mortars with residue a decrease in the resistances has occurred. In the absorptions some subfamilies had better performance than the reference mortar. For the prototypes the use of rubber did not influence the behavior of the mortar coating and the permeability by the pipe method was shown without significant differences in the results obtained.